The Spring Fever Pedal is reminiscent of a vintage tube, long spring reverb unit with three easy to use controls. It has 3 analog amplifers. One for the dry guitar signal, one in front of the spring module to warm it up, and an analog amplifier on the output to warm it up again.
* Volume Control - This is a transparent line boost that can give more gain if desired that works well as an end of a chain boost.
* Reverb Control - It works like a dwell control that puts more signal to the spring simulator
* Mix Control - Mixes the wet and dry signal
* Power 9-volt 200 mA center pin ground input jack 2.1mm (no battery).
Important: It is not recommended to use the Boss PSA-120s power supply. The Spring Fever pedal may not match up and operate as well with this power supply. - All power supplies are not created equal. You must use a quality regulated DC 9 volt (negative center pin) power supply for quiet operation. An isolated ground supply like Voodoo Labs is even better. Some power supplies add excess noise and high pitch oscillation with ToneCandy pedals. This is not coming from the pedal. It is from the power supply. You will not notice it as much on an overdrive pedal because it is already producing distortion that can cover up noise.
Buy Now TONE CANDY SPRING FEVER REVERB at Musicarte Musical Instruments
Product Condition & Warranty
condition: USED. Used product, condition checked by Musicarte, 12 months warranty.
Shipping Cost Outside Italy
Shipping costs for orders outside Italy are calculated by our shipping company, you will be able to view this costs in our checkout page, before completing your order.
Estimated Shipping Time
Shipping outside Italy may take from 2 to 5 working days.